We and our partners use technologies, such as cookies, to recognize you and show you more of what you like. Please read our Privacy Policy to learn more. By using this website you agree to the use of those technologies.
I agree.
After the overhaul and CLA on my Leica IIIF and newly inherited Jupiter-8 Red P camera is working perfect. On some picture you can see a exposure shift it's not the negatives nor the camera it was the lack of even lighting while scanning but you can notice this on very little pictures. I have to learn how to diffuse the light more proper but for now this works fine to me. The Jupiter-8's alignment were off and it was focusing at infinity on 7 meter when I had first inherited it. After a full disassembly and repair on the alignment (which is quite common on these Red P Jupiter-8's). On the first frames you can see that they are all double exposures. That's because while I was waiting for my leica to come back to me I shot couple frames with my Zorki 1E. But after I got my leica back I took the roll out of the zorki and reload it into my leica. I thought I was at 7th frame and I shot until the count dial came into the 7th but it turns out it was still short (user error, my bad.) It is quite funny though (Murphy Law.) because I normally always shot couple empty frames more just to be ''sure'' that I am not too short but this time I felt over-encourage about myself and thought that I was ''sure'' about the frame count. (Murphy smiling again.) anyways don'T think all of the frames are Jupiter-8 though some of them are Voigtlander Color Skopar 35mm. I will try to Mark the 35mm ones with a different description on the start after I upload them all. All of the pictures are taken between Jan-February 2022 in Ankara Turkei. Self developed with ID-11 9 min at 20° - Fixer 1min agitate and 13 min wait - 30 sec Ilfostop and soapy distilled water. Washed the tank 3 times each between all of the steps. I still have 4 or 5 rolls of Fomapan 100 so you will keep seeing the same stock for a while. I am quite enjoying this stock who knows maybe I'll keep using it. !!! I had to cut the film into two pieces because I accidentaly spooled too many frames then I must had. My bulk loader tank does not work properly so I cannot count the frames thats why this error happened. I couldn't put the entire roll into one spiral because it was too long to put. You can see it created some marks and scratches on some of the portraits. It's because that place was the part where it was the natural spool's end so it wasnt moving any further I had to cut it from there and then put the remaining second piece to the second spiral.
未有留言